CH wheel spacers

[NABZY]

Hey legends, I got a 2.4 CH Limited edition with the 15 inch OZ racing wheels. It’s lowered on coils but the the offset looks so weird. I want to push the wheels out with spacers but idk how much thread will be left for the lug, then if I get an eBay set of the thicker spacers with the thread attached to it I’d have to cut the original threads to for it to sit flush.
I hope this all makes sense.
Has anyone gone through what I’m going through atm or if there’s any other suggestions?

Thanks!!

 

[unclepaulie]

if those oz racing wheels have reliefs in the back of the wheel centre, you might be able to get away with bolt on spacers.

measure how much you want to space the wheels out
measure the length of the studs
measure the depth of the reliefs

the length of the studs - amount of spacing required = left over threads

if left over threads is less than the depth of the reliefs, you're fine.

then you just need to order the spacers with the right hub bore. make sure you get hub centric ones. and tighten the nuts to the correct spec and mark them with a paint pen to visually check for loosening reguarly.

NOTE: spacers are technically illegal in all states of Australia.