CH 2.0l exhausts
- Thread starter alexmaher
- Start date
MazioBarditore
Member
Extractors: The two choices are 4-2-1 and 4-1
4-1 are good for high rpm torque, usually 5-6k rpm upwards. Since the limiter is at about 6000 for 2.0l CH, unless you are raising your limiter then they will likely be a waste of money as you will not get the most out of this design.
4-2-1 would probably suit better, more low-mid range torque therefore quicker off the line, and you feel the full benefits of these without having to raise the rev limiter.
Hurricane are a good brand, they make 4-1 for the 2.0l and 4-2-1 for the 1.8l, but since the 1.8l has the same engine head as the 2.0l, the 4-2-1 will also fit.
As for high flow cat, there's no real need for one of these, the gains are minimal for the money you pay for them
4-1 are good for high rpm torque, usually 5-6k rpm upwards. Since the limiter is at about 6000 for 2.0l CH, unless you are raising your limiter then they will likely be a waste of money as you will not get the most out of this design.
4-2-1 would probably suit better, more low-mid range torque therefore quicker off the line, and you feel the full benefits of these without having to raise the rev limiter.
Hurricane are a good brand, they make 4-1 for the 2.0l and 4-2-1 for the 1.8l, but since the 1.8l has the same engine head as the 2.0l, the 4-2-1 will also fit.
As for high flow cat, there's no real need for one of these, the gains are minimal for the money you pay for them