CE Lancer/Mirage Bulb List

donki

donki

Administrator
Forum Administrator
Headlights: H4 hi/low bulbs
Foglights: H3
Boot: 31mm festoon
Dome: 31mm festoon
License plate: 2x T10
Cluster: 4x T10 & 1x T5
Center Dash: 4x T5
Parkers: 1x T10
Sidemarkers: 1x T10
Brake Lights: 2pin bayonette fittings
Reverse & Rear Indicators: single pin bay fittings
Front Indicators: single pin bay fittings

List by Res`
Edit: and Rigby
 
what about foglight switch, power window switch, aircon switch and demister switch? i believe they are some sort of miniature neo wedge bulb, not 100% sure on which type though
 
Mr_LanRydar said:
what about foglight switch, power window switch, aircon switch and demister switch? i believe they are some sort of miniature neo wedge bulb, not 100% sure on which type though
Click to expand...

i think they are a t2? (seems to spring to mind)

i did a diy on it a while ago on replacing all of these with a led, skippy did one for people with climate control too.

viewtopic.php?f=41&t=2383


Res said:
sidewayz said:
Foggies. I h7 Yea?

Sent from my GT-I9505 using Tapatalk
Click to expand...
pree sure H3 mang
Click to expand...

Triangle fogs are deffs H3, i assume round ones are the same.
 
Hi just a quick question inregards to the foglight switch. Does it have a light inside the switch itself cause mine doesn't inluminate when off or on thanks
 
Blackmustafa said:
Hi just a quick question inregards to the foglight switch. Does it have a light inside the switch itself cause mine doesn't inluminate when off or on thanks
Click to expand...

Yes it does
Ive never known for anyone to have it working, even from factory
 
donki said:
Blackmustafa said:
Hi just a quick question inregards to the foglight switch. Does it have a light inside the switch itself cause mine doesn't inluminate when off or on thanks
Click to expand...

Yes it does
Ive never known for anyone to have it working, even from factory
Click to expand...

Not having a factory MR or the wiring diagrams on hand i can't say for certain where each wire goes to. But i do know on the switch plug there are six wires, the thinnest of which hook up to the light inside the switch. You can simply cut these and extend one to ground (if it is not already, need to check diagrams) and extend the other to an illumination wire which you can tap into ie. back or the cluster. This is what i did, and it now turns on along with the other ill lights.
 
You must log in or register to reply here.
Back
Top