engine

Hi all, I have a 2009 lancer cj with the stock 2.4L engine, everything in the car is stock except exhaust and visual mods, but it has had a whirring noise for a long while now, atleast a year. The noise sounds like something spinning and gets louder as revs go up, its automatic but there is no...

More a technical discussion than anything else , did copy paste to an engine discussion board hence why it's so vague about Lancers lmao but I feel this is a good place to post also Wanted to get kinda a general discussion going about engine sizing and outputs etc more than about my actual car...

Hi guys, Just after a work shop manual for the 4G94 SOHC engine. I found one online, but I am not convinced it is right, as the valve clearances for the IN and EX say 0.09 and 0.2 respectively. On the underside of my hood, there is an OEM Mitsubishi sticker, it says 0.2 and 0.3 respectively. So...

Evening people! First post here. Just came looking for some posts in regards to swapping my engine out. I have done something very bad to my 2003 Lancer CH (has an auto trans). Chipping metal out into the oil pan, and sounds like a gun going off in cylinder 4. Anyways, I have a "new to me"...

(first post on here, sorry if I do something wrong) I have a 1994 CE Lancer Wagon, 260,000km on the clock. Slowly over the last few years I'm fairly sure I'm noticing a decrease in power across the rev range. Definitely a dramatic decrease in power at low RPM and when cold. I've been running...

So pulling the 4g93 (1.8L) out of my 2000 CE lancer I've done RWD but never a FWD and wondering what do i do about the drive shafts, do i have to completely remove them from hub and gear box or can i just flick them out of the gear box and leave them attached to the hubs? Thanks for any info.