Phasehalide
New Member
I'm happy to inform everyone i finally found the culprit to my main performance/rich mixture issues and the car as of today roars as it should and all my power i was expecting is all there now! I have no more problems the car is running as i expected it to very nicely i might add with no more popping of unburnt fuel in the exhaust and no more excessive fuel consumption.
I have had a huge smile on my face all day long and still do all that hard work has finally payed of today!
It all came down to one wire being wrong! When i was doing all that wiring work and converting the loom from being an auto to a clean manual i removed all the auto CPU stuff there was only one wire that i was not to sure about and found that when i connected it to a 12V rail it would start up the fuel pump when i had the key in the IGN position so i thought it was meant to be like that. That wire is a Black/Red striped one that used to go from pin #71 (Started Signal) on the ECU's B-37 plug and went to the auto CPU, i don't know why but at the time it didn't give much attention to it because the car was running alright. Long story short after i disconnected it today before going out to log some runs with EvoScan it transformed the car completely and i could not stop laughing! I think i need to connect that wire up to the starter motor Signal as it should be
The ECU must have thought i was Cranking the hell out out of it! :lolno:
I also have found a 13KB definition file for my ECU's Rom that works with ECUFlash and allows me to see my maps but i don't think it points to enough memory addresses and is maybe incomplete, i would really appreciate it if anyone with knowledge on this subject could help me with a better def file or some way so i can add: 2byte_load, Mut Tables etc.
I can upload my Rom and Def files if anyone is up to the task of checking it out for me and helping also any advice whatsoever would be awesome because i do understand quite a bit of what i am looking at but i am still very novice after all this being the first time i am doing this.
Cheers
I have had a huge smile on my face all day long and still do all that hard work has finally payed of today!
It all came down to one wire being wrong! When i was doing all that wiring work and converting the loom from being an auto to a clean manual i removed all the auto CPU stuff there was only one wire that i was not to sure about and found that when i connected it to a 12V rail it would start up the fuel pump when i had the key in the IGN position so i thought it was meant to be like that. That wire is a Black/Red striped one that used to go from pin #71 (Started Signal) on the ECU's B-37 plug and went to the auto CPU, i don't know why but at the time it didn't give much attention to it because the car was running alright. Long story short after i disconnected it today before going out to log some runs with EvoScan it transformed the car completely and i could not stop laughing! I think i need to connect that wire up to the starter motor Signal as it should be
The ECU must have thought i was Cranking the hell out out of it! :lolno:
I also have found a 13KB definition file for my ECU's Rom that works with ECUFlash and allows me to see my maps but i don't think it points to enough memory addresses and is maybe incomplete, i would really appreciate it if anyone with knowledge on this subject could help me with a better def file or some way so i can add: 2byte_load, Mut Tables etc.
I can upload my Rom and Def files if anyone is up to the task of checking it out for me and helping also any advice whatsoever would be awesome because i do understand quite a bit of what i am looking at but i am still very novice after all this being the first time i am doing this.
Cheers
